Safety Instruction Guide for RCBS Full Length 2Die Set 9.3mm x 62
Introduction
Thank you for purchasing the RCBS Full Length 2Die Set for 9.3mm x 62. This guide provides essential safety information and instructions to ensure the safe and effective use of your reloading equipment. Please read this guide carefully before using the product.
General Safety Guidelines
- Always wear appropriate safety gear, including safety glasses and gloves, when reloading ammunition.
- Ensure that your reloading area is wellventilated and free from distractions.
- Keep all reloading materials, including primers and powders, out of reach of children and pets.
- Store your reloading equipment and materials in a secure location.
- Regularly inspect your dies and equipment for signs of wear or damage before use.
- Report any unsafe products or accidents to the appropriate authorities.
Specific Safety Precautions for Use
- Hazard Identification: Be aware of potential hazards, including:
- Improperly sized cases leading to firearm malfunctions.
- Use of unlubricated cases causing stuck cases in the die.
- Incorrect die adjustments leading to unsafe ammunition.
- Avoiding Hazards:
- Always use a cartridge headspace gauge tool to ensure correct shoulder bump.
- Lubricate cases before fulllength sizing to prevent damage to the die and stuck cases.
- Follow the manufacturer's instructions for die adjustments to ensure proper bullet seating and crimping.
- AgeSpecific Warnings: This product is intended for use by adults and should not be used by children without adult supervision.
Instructions for Installation and Usage
Setting Up the Die:
- Secure the die in the press according to the manufacturer's instructions.
- Adjust the die to achieve the desired shoulder bump using a cartridge headspace gauge tool.
Preparing Cases:
- Clean and inspect cases before reloading.
- Apply appropriate lubricant to the cases to ensure smooth sizing.
Sizing the Cases:
- Insert the lubricated case into the sizing die and operate the press to size the case.
- Ensure the die is correctly adjusted for fulllength sizing.
Seating the Bullets:
- Use the seater die to place bullets into the sized cases.
- Adjust the seater die to achieve the desired bullet seating depth.
- If crimping is desired, adjust the die to crimp the case onto the bullet securely.
Final Inspection:
- Inspect the finished ammunition for any defects or irregularities.
- Store completed ammunition in a safe and secure location.
Disposal Instructions
- Dispose of any unused or expired reloading materials according to local regulations.
- Ensure that all hazardous materials, such as primers and powders, are disposed of safely and responsibly.
Contact Information for Further Support
For safety inquiries or further assistance, please refer to the manufacturer's contact information provided with your product or visit the official website.
Thank you for your attention to safety while using the RCBS Full Length 2Die Set. Your commitment to safe reloading practices helps ensure a positive experience in your reloading endeavors.