Safety Instruction Guide for CASE LENGTH GAUGES LEE PRECISION LEE LENGTH GAUGE/ SHELLHOLDER, 7MM REM MAG
Introduction
Thank you for choosing the CASE LENGTH GAUGES LEE PRECISION LEE LENGTH GAUGE/ SHELLHOLDER, designed for precise case trimming and squaring the case mouth. This guide provides essential safety instructions and usage guidelines to ensure a safe and effective experience with the product.
General Safety Guidelines
- Product Safety: Always ensure that your CASE LENGTH GAUGE is used according to the instructions provided. This product is designed for nonfood use and should be handled with care.
- Enhanced Recalls: In the event of a product recall, standardized notices will be issued, and free remedies will be provided for dangerous products. Stay informed about any updates regarding this product.
- Online Shopping Safety: When purchasing online, ensure that the platform complies with safety requirements similar to those of physical stores.
- Special Consumer Focus: Extra precautions are advised for vulnerable groups, such as children. Keep the product out of reach of children.
- EU Contact Point: For any safety inquiries, please refer to the designated EUbased contact point for this product.
- Rapid Alerts: Stay updated on unsafe products through the EU’s Safety Gate system.
Specific Safety Precautions for Use
- Before using the CASE LENGTH GAUGE, inspect the product for any visible damage. Do not use if damaged.
- Always wear appropriate safety gear, such as safety glasses, to protect your eyes during operation.
- Keep hands clear of the cutting area while operating the gauge.
- Ensure the gauge is securely attached to the cutter and lock stud before use.
- Follow the manufacturer's instructions for trimming and squaring cases to avoid injury.
- Do not exceed the recommended cartridge specifications; this gauge is designed specifically for 7 mm Remington Magnum cartridges.
- Store the gauge in a safe, dry place when not in use to prevent rust or damage.
Instructions for Installation and Usage
Installation:
- Ensure all components are clean and free from debris before assembly.
- Attach the CASE LENGTH GAUGE to the cutter and lock stud securely.
- Verify that the gauge is properly aligned before proceeding.
Usage:
- Insert the cartridge into the gauge, ensuring it is seated correctly.
- Rotate the cutter gently to trim the case to the desired length.
- After trimming, check the case mouth for squareness. If necessary, repeat the process until the desired result is achieved.
- Remove the trimmed cartridge from the gauge carefully to avoid injury.
Disposal Instructions
- Dispose of any damaged or unusable components in accordance with local regulations.
- Do not dispose of the product in household waste. Instead, take it to a designated recycling facility if available.
- Ensure that all parts are disposed of in a manner that prevents harm to the environment.
Contact Information for Further Support
For additional information or support regarding the CASE LENGTH GAUGES LEE PRECISION LEE LENGTH GAUGE/ SHELLHOLDER, please refer to the designated contact point provided with your product.
By following these safety instructions, you can ensure a safe and effective experience while using the CASE LENGTH GAUGES LEE PRECISION LEE LENGTH GAUGE/ SHELLHOLDER, 7MM REM MAG. Thank you for your attention to safety and proper usage.