Forster Full Length Sizing and Bench Rest Seater Die Sets Safety Instructions
Introduction
Thank you for choosing the Forster Full Length Sizing and Bench Rest Seater Die Sets. This guide provides essential safety instructions to ensure the safe and effective use of this product. Please read and understand these guidelines before using the dies.
General Safety Guidelines
- Ensure that the product is used only for its intended purpose.
- Always wear appropriate safety gear, including safety glasses, when reloading ammunition.
- Keep the workspace clean and organized to prevent accidents.
- Store dies and reloading equipment out of reach of children and unauthorized users.
- Regularly inspect equipment for wear or damage. Do not use damaged dies.
- Follow all local laws and regulations regarding ammunition reloading.
Specific Safety Precautions for Use
- Always doublecheck that the die is properly installed before use.
- Use only compatible cartridges with the Forster Full Length Sizing Die and Seater Die.
- Avoid overtightening the die locking ring, as it may cause damage to the die or press.
- Do not attempt to modify the dies or use them for purposes other than intended.
- Ensure that the workspace is wellventilated, especially when working with primers and powders.
- Keep hands and face clear of the die during operation to prevent injury.
Instructions for Installation and Usage
Installation of the Dies:
- Remove the die from its packaging and inspect for any visible damage.
- Clean the die with a soft cloth to remove any protective oils.
- Insert the sizing die into your reloading press and handtighten the locking ring.
- Insert the seater die in the same manner.
Using the Full Length Sizing Die:
- Adjust the die to the required height based on your reloading press specifications.
- Place an empty cartridge case in the shell holder of the press.
- Pull the handle to size the case fully.
- Remove the sized case and check for proper dimensions.
Using the Bench Rest Seater Die:
- Place a bullet on the mouth of the cartridge case.
- Insert the case into the shell holder of the press.
- Pull the handle to seat the bullet to the desired depth.
- Inspect the completed round for proper bullet seating.
Disposal Instructions
- Dispose of any defective or wornout dies in accordance with local regulations.
- Do not throw dies in regular household waste. Check with local authorities for proper disposal methods.
- Ensure that all packaging materials are recycled or disposed of responsibly.
Contact Information for Further Support
For any safety inquiries or concerns, please consult the manufacturer or your local retailer. Always refer to the product's warranty and support information provided at the time of purchase.
Thank you for following these safety instructions. Enjoy your reloading experience with the Forster Full Length Sizing and Bench Rest Seater Die Sets!