Safety Instruction Guide for OPTIONAL 17 AND 20 CAL ROD REDDING
Introduction
Thank you for choosing the OPTIONAL 17 AND 20 CAL ROD from Redding. This product is designed to assist with decapping and cleaning cases prior to sizing. It is important to follow safety guidelines to ensure safe and effective use of this product. This guide outlines essential safety instructions, precautions, and disposal methods.
General Safety Guidelines
- Ensure you read and understand all instructions before using the product.
- Keep this product out of reach of children and vulnerable individuals.
- Use the product only for its intended purpose as described in this manual.
- Inspect the product for damage before each use. Do not use if damaged.
- Follow all local regulations regarding the use and disposal of reloading products.
Specific Safety Precautions for Use
- Always wear appropriate eye protection when using decapping dies and accessories.
- Ensure that your workspace is clean and free of obstructions to avoid accidents.
- Keep hands and other body parts clear of moving parts during operation.
- Do not exceed the recommended case lengths and calibers as specified in the product description.
- Be cautious of sharp edges and points on the die and rod.
- If you experience any discomfort or unusual reactions while using the product, stop immediately and consult a professional.
Instructions for Installation and Usage
Preparation:
- Gather all necessary tools and materials including the OPTIONAL 17 AND 20 CAL ROD, decapping dies, and a suitable reloading press.
- Ensure your workspace is clean and organized.
Installation:
- Follow these steps to install the OPTIONAL rod:
- Remove the existing decapping rod from the decapping die, if applicable.
- Insert the OPTIONAL rod into the decapping die, ensuring it fits securely.
- Tighten any set screws or locking mechanisms to hold the rod in place.
Usage:
- To use the decapping die with the OPTIONAL rod:
- Place the case into the shell holder of the reloading press.
- Raise the ram to bring the die into contact with the case.
- Ensure that the flash hole is aligned with the decapping pin.
- Apply steady pressure to deprime the case.
- Lower the ram to remove the case from the die.
- For cases with small .060 inch flash holes, ensure the OPTIONAL rod is correctly installed for proper functionality.
PostUsage:
- Clean the die and rod after each use to prevent corrosion and ensure longevity.
- Store the OPTIONAL rod and dies in a safe, dry place away from children.
Disposal Instructions
- Dispose of any damaged or unusable parts according to local regulations for hazardous waste.
- Do not throw away in regular household trash.
- If unsure about disposal methods, contact local waste management authorities for guidance.
Contact Information for Further Support
- For any inquiries or concerns regarding the OPTIONAL 17 AND 20 CAL ROD, please refer to the manufacturer’s contact information provided with your product packaging.
Thank you for following these safety guidelines. Your careful attention to these instructions will help ensure a safe and effective reloading experience.