Safety Instruction Guide for Walther PPQ M2 Vortex Razor Sight Mount
Introduction
Thank you for choosing the Walther PPQ M2 Vortex Razor Sight Mount. This guide provides essential safety instructions and installation details to ensure the safe and effective use of your product. Please read this guide carefully before use.
General Safety Guidelines
- Product Safety: Ensure safe use of the sight mount by following all instructions provided in this guide.
- Enhanced Recalls: Stay informed about any recalls or safety notices related to this product.
- Online Shopping: If purchased online, verify that the seller meets safety requirements.
- Special Consumer Focus: This product is intended for adult use only. Keep out of reach of children.
- EU Contact Point: For any safety inquiries, refer to the appropriate EU contact for support.
- Rapid Alerts: Check the EU Safety Gate platform for updates on any unsafe products.
Specific Safety Precautions for Use
- Always ensure that the firearm is unloaded before installing or removing the sight mount.
- Do not use the sight mount if it appears damaged or defective.
- Ensure that all mounting screws are tightened properly to prevent the sight from becoming loose during use.
- Avoid using excessive force when tightening screws to prevent damage to the mount or the firearm.
- Use the sight mount only with compatible red dot sights (Vortex Razor, CMore RTS & STS).
- Do not modify the sight mount or firearm in any way that may affect safety or performance.
- Regularly inspect the sight mount for wear and tear, and replace it if necessary.
Instructions for Installation and Usage
- Remove the Rear Sight: Carefully remove the rear sight from your Walther PPQ M2.
- Install the EGW Sight Mount:
- Place the EGW Sight Mount into the dovetail where the rear sight was located.
- Ensure it is seated properly.
- Tighten Set Screw: If applicable, tighten the set screw to secure the mount.
- Place the Red Dot Sight:
- Position the red dot sight on the EGW Sight Mount.
- For easier removal, place a small piece of paper between the red dot sight and the mount to prevent Loctite from getting on the sight.
- Apply Blue Loctite: Apply blue Loctite to the provided mounting screws to secure the sight.
- Torque Mounting Screws: Tighten the mounting screws to a torque of 15 in/lbs.
Disposal Instructions
- Dispose of the sight mount and any packaging materials in accordance with local regulations.
- Do not dispose of the product in general household waste. Check for designated recycling centers for proper disposal.
Contact Information for Further Support
For any questions or concerns regarding the Walther PPQ M2 Vortex Razor Sight Mount, please refer to the manufacturer's contact information or consult the retailer from whom you purchased the product.