DOVETAIL SCOPE BASE STOCK SAFETY INSTRUCTIONS
Introduction
Thank you for choosing the Dovetail Scope Base Stock by Brownells. This product is designed to assist you in mounting scopes securely and effectively. Please read this safety instruction guide carefully to ensure safe usage and compliance with EU regulations.
General Safety Guidelines
- Ensure that the product is used only for its intended purpose.
- Always inspect the product for any signs of damage before use.
- Keep the product out of reach of children and vulnerable individuals.
- Follow all installation and usage instructions provided in this guide.
- Report any unsafe conditions or product malfunctions to the appropriate authorities.
- Stay informed about product recalls by checking the EU’s Safety Gate platform.
Specific Safety Precautions for Use
- Use protective eyewear when cutting or drilling the scope base stock to prevent injury from flying debris.
- Ensure your workspace is clean and free of hazards before beginning installation.
- Always use the correct tools as specified in the installation instructions.
- Do not exceed the specified dimensions and weight limits when mounting scopes.
- Be cautious of sharp edges when handling the Dovetail Scope Base Stock.
- Avoid using the product in extreme weather conditions, which may affect its performance.
Instructions for Installation and Usage
Preparation
- Gather all necessary tools, including a saw, drill, countersink bit, and finishing materials (AlumaHyde™ or Baking Lacquer).
- Ensure that your workspace is welllit and organized.
Cutting
- Measure the required length of the Dovetail Scope Base Stock.
- Use a saw to cut the stock to the desired length. Ensure that the cut is straight and even.
Drilling and Countersinking
- Mark the locations for holes where the scope rings will be attached.
- Use a drill to create holes at the marked locations.
- Countersink the holes to ensure the screws sit flush with the surface.
Finishing Exposed Ends
- After cutting and drilling, use AlumaHyde™ or Baking Lacquer to refinish the exposed ends.
- Allow adequate time for the finish to dry according to the manufacturer's instructions.
Mounting the Scope
- Attach the scope rings that fit a 3/8" nominal dovetail to the base.
- Ensure that all screws are tightened securely to prevent movement during use.
Final Inspection
- Doublecheck all connections and ensure that the scope is mounted securely.
- Perform a test to ensure the scope is aligned properly before use.
Disposal Instructions
- Dispose of any leftover materials and packaging in accordance with local regulations.
- Do not dispose of the product in household waste. Instead, check for local recycling programs that accept aluminum materials.
Contact Information for Further Support
For any further assistance or inquiries regarding safety, installation, or product performance, please contact your local distributor or refer to the manufacturer’s website for support resources.
Thank you for your attention to these safety instructions. Enjoy using your Dovetail Scope Base Stock responsibly!