CZ SHADOW 2 TRIJICON RMR SIGHT MOUNT Safety Instruction Guide
Introduction
Thank you for choosing the CZ SHADOW 2 TRIJICON RMR SIGHT MOUNT. This guide provides essential safety instructions and installation information to ensure safe and effective use of the product. Please read this manual carefully before use.
General Safety Guidelines
- Product Safety: Ensure the mount is used only as intended. Follow all instructions to minimize risks.
- Enhanced Recalls: Stay informed about any product recalls through official channels.
- Online Shopping: If purchased online, ensure the seller complies with safety standards.
- Special Consumer Focus: This product is not intended for children. Keep out of reach of minors.
- EU Contact Point: For safety inquiries, please refer to the designated EU contact point.
- Rapid Alerts: Monitor the EU Safety Gate platform for updates on product safety.
Specific Safety Precautions for Use
- Potential Hazards:
- Improper installation may lead to the failure of the mount and could cause injury or damage.
- Ensure the mount is compatible with your firearm before installation.
- Avoiding Hazards:
- Always check for any visible damage before use.
- Do not exceed the recommended torque specifications during installation.
- Age Restrictions:
- This product is designed for adult users only.
Instructions for Installation and Usage
Remove the Rear Sight:
- Carefully detach the rear sight from your firearm.
Install the EGW Sight Mount:
- Place the EGW Sight Mount into the dovetail of the firearm.
- Ensure it is properly aligned.
Tighten Set Screw:
- If applicable, tighten the set screw to secure the mount.
Place the Red Dot Sight:
- Position the Trijicon RMR red dot sight on the EGW Sight Mount.
- For easier removal, place a small piece of paper between the sight and the mount.
Apply Loctite:
- Use blue Loctite on the provided mounting screws to secure them.
Torque Mounting Screws:
- Tighten the mounting screws to a torque of 15 in/lbs.
Use of Provided Screws:
- The included flat head cap screws require a 5/64” allen wrench for installation.
Disposal Instructions
- Dispose of the product in accordance with local regulations.
- Do not dispose of the product in household waste.
- Check with local waste management authorities for proper disposal methods.
Contact Information for Further Support
For further inquiries and support, please refer to the designated EU contact point associated with this product.
Thank you for your attention to these safety guidelines. Your safety and satisfaction are our top priorities.