Safety Instruction Guide for HEX DRIVE BUSHINGS CHALLIS GRIPS 1911
Introduction
Thank you for choosing the HEX DRIVE BUSHINGS CHALLIS GRIPS 1911. This product is designed to enhance your grip experience while ensuring safety and reliability. Please read this safety instruction guide carefully to understand how to use the product safely and effectively.
General Safety Guidelines
- Product Safety: This product is designed for safe use in nonfood applications. Ensure that you follow all guidelines to avoid risks.
- Enhanced Recalls: In the event of a safety issue, recall notices will be provided, and free remedies will be available for dangerous products.
- Online Shopping: When purchasing online, ensure that the platform adheres to safety requirements similar to physical stores.
- Special Consumer Focus: Extra precautions should be taken for vulnerable groups, especially children.
- EU Contact Point: For safety inquiries, ensure there is a designated EUbased contact.
- Rapid Alerts: Stay updated on unsafe products through the EU's Safety Gate system.
Specific Safety Precautions for Use
- Always inspect the bushings for any signs of wear or damage before installation.
- Ensure that the nut driver used is 7/32” to avoid stripping the hex head.
- Do not overtighten the bushings, as this may distort them or damage your firearm.
- Use Orings to secure grips and minimize shock; replace Orings if they show signs of wear.
- Keep the product out of reach of children and pets to prevent accidental injury.
- If you experience any unusual sounds or resistance during installation, stop immediately and reassess the situation.
Instructions for Installation and Usage
Preparation:
- Gather necessary tools: a 7/32” nut driver and optional Orings.
- Ensure the firearm is unloaded and pointed in a safe direction.
Installation:
- Remove existing bushings from the grip frame.
- Clean the area where the bushings will be installed to ensure a proper fit.
- Insert the new Challis hex drive bushings into the grip frame.
- Using the 7/32” nut driver, gently tighten the bushings until secure. Avoid overtightening.
- If using Orings, place them onto the bushings before attaching the grips.
Usage:
- Regularly check the tightness of the bushings, especially after heavy use.
- Monitor for any signs of loosening or damage to the bushings or grips.
Removal:
- To remove the bushings, use the same 7/32” nut driver.
- Unscrew the bushings gently to avoid damaging the frame or the bushings themselves.
Disposal Instructions
- Dispose of the product in accordance with local regulations for nonhazardous waste.
- Do not dispose of in general household waste if the product shows signs of damage or wear.
- Consider recycling options where available.
Contact Information for Further Support
For any questions or concerns regarding the HEX DRIVE BUSHINGS CHALLIS GRIPS 1911, please refer to the contact information provided with your purchase.
Thank you for your attention to these safety guidelines. Enjoy your enhanced grip experience with confidence!